Full G Road Test Checklist (Ontario, Printable)

Preparation and Vehicle Checks

Before the Test

Bring Required DocumentsEnsure you have your valid G2 driver's licence, vehicle registration, and proof of insurance.
Vehicle Walk-aroundMake sure your vehicle is in good working order (lights, signals, horn, no cracked windshields).
Adjust Seat and MirrorsAdjust your seat and mirrors for maximum visibility before putting the car in gear. Fasten your seatbelt.

During the Test

Entering the ExpresswayCheck traffic, mirrors, and blind spots. Signal early, accelerate to match highway speed in the acceleration lane, and merge smoothly.
Driving AlongCheck mirrors every 5-10 seconds. Maintain safe spacing (2-3 seconds following distance) and drive at the posted speed limit.
Exiting the ExpresswayCheck mirrors and blind spots. Signal well in advance, enter the deceleration lane without slowing down prematurely, and reduce speed smoothly.

During the Test

Approach and Traffic CheckCheck traffic (mirrors and blind spots) before turning. Ensure you are in the correct lane and signal early.
Stopping (If Applicable)Come to a full stop without blocking the crosswalk. Keep wheels straight while waiting to turn left.
Turning MechanicsUse hand-over-hand steering. Maintain a safe speed and avoid turning too wide or cutting corners short.
Completing the TurnFinish in the proper lane (right-most for right turns, appropriate lane for left turns) and resume traffic speed.

During the Test

Approach SafelyScan left and right before entering. Cover the brake if a hazard is present and maintain a safe gap.
Stopping CorrectlyMake a full stop behind the stop line or crosswalk. Do not block traffic or pedestrians.
Driving ThroughEven if you have the right-of-way (green light), check traffic left and right before proceeding through the intersection.

During the Test

Comprehensive Traffic CheckCheck front, left, right, and mirrors. Always perform a shoulder check (blind spot) before moving.
Signal and SpaceSignal your intention early. Ensure adequate spacing in front and behind you in the new lane.
Smooth ExecutionSteer smoothly into the center of the new lane while maintaining your speed. Cancel your signal after completing the move.

During the Test

Constant ScanningCheck mirrors frequently (every 5-10 seconds). Look for potential hazards like pedestrians, parked cars, or side streets.
Lane PositioningStay in the correct lane and position. Do not wander or straddle lanes.
Speed and SpacingObey speed limits carefully and maintain a 2-3 second following distance.

During the Test

Roadside StopSignal, pull over parallel to the curb (within 30cm), shift to park/neutral, and apply the parking brake.
Three-Point TurnCheck traffic thoroughly before each movement. Signal properly and avoid hitting the curb or making unnecessary forward/backward movements.
Parallel ParkingSignal your approach. Back in smoothly using no more than 3 pull-ups. Park parallel within 30cm of the curb and secure the vehicle.

During the Test (Instant Fails)

Preventable CollisionAny contact with another vehicle, pedestrian, or object due to driver error.
Dangerous Action / Law ViolationRunning a red light, speeding, or forcing the examiner to intervene to prevent a dangerous situation.
Inadequate SkillDemonstrating a general lack of control or accumulating too many minor driving errors across the test.

Post-Drive Procedures

Secure the VehicleOnce parked back at the DriveTest centre, put the vehicle in Park, apply the parking brake, and turn off the engine.
Listen to FeedbackThe examiner will tally your scoresheet and point out any errors or areas for improvement.
Upgrade to Full GIf you pass, proceed inside the DriveTest centre to finalize your fully licensed G status.

Ticks are saved in this browser only. The same checklist is in the Roadity app.